| Author |
Step by step guide to install DCU-60 USB Flash Driver |
WotanServer
Joined: May 03, 2006
Posts: 104
PM, WWW
|
If you did not flash phone on your PC using DCU-60 cable yet, you have to install USB Flash Drivers.
1. download driver from http://www.wotanserver.com/USBFlashDriver.exe following dialog will appers. Push "Run" button.
1b. Depends on your Windows security dialog can apper also. Again push "Run" button.
2. Push "Install" button. Drivers will be extracted to "C:USBFlashDriver" and window closes automaticaly.
3. Connect DCU-60 cable to USB port.
4. Connect your phone with keep pressed C to the cable.
5. Dialog "Found New Hardware Wizard" occurs. Choose "No, not this time" and push "Next >" button.
6. Choose "Install from a list or specific location (Advanced)" and push "Next >" button.
7. Choose "Search for the best driver in these locations", check
"Include this location in the search"m push "Browse" button and choose
folder where you extracted USBFlashDriver.exe archive (by default is
extracted to C:USBFlashDriver) and push "Next >" button
8. Click "Continue Anyway"
9. Push "Finish" button
USB Flash Driver is installed. You can start using WotanClient software.
[ This Message was edited by: WotanServer on 2006-06-06 11:39 ] | |
|
jezzz
Joined: Aug 21, 2006
Posts: 3
PM |
it seems this doesnt work on a j230..it says unsupported accessory,then there's no new hardware found.
what's wrong with this, is it tha cable or the phone itself? | |
|
Access the forum with a mobile phone via esato.mobi
|
Posted: 2006-06-06 12:37
